Constant Voltage TRIAC&0-10V Dimmable Driver for single or dual color IP67
● Constant voltage output,50/60Hz
● Aluminum case with cable,Class I, IP67
● Built-in EMI filter with tiny ripple,flicker-free
● High performace and reliability
● Typical lifetime ≥ 50000 hours
● 100% full load bur-in test
● Protection: Short circuit/Over voltage/Over load
● 2 years warranty
| Model | Power | Input Voltage | Output Voltage | Output Current | Efficiency | PF | Dimension | Weight | Warranty |
| NC-12060-TOWS | 60W | 180-260Vac | 12V | 5A | >83% | >0.6 | 240*50*35mm | 350g | 2 years |
| NC-24060-TOWS | 24V | 2.5A | |||||||
| NC-12100-TOWS | 100W | 180-260Vac | 12V | 8.3A | >85% | >0.6 | 240*50*35mm | 580g | 2 years |
| NC-24100-TOWS | 24V | 4.2A | |||||||
| NC-12150-TOWS | 150W | 180-260Vac | 12V | 12.5A | >87% | >0.6 | 305*50*35mm | 750g | 2 years |
| NC-24150-TOWS | 24V | 6.2A | |||||||
| NC-12200-TOWS | 200W | 180-260Vac | 12V | 16A | >88% | >0.6 | 305*50*35mm | 760g | 2 years |
| NC-24200-TOWS | 24V | 8A | |||||||
| NC-12250-TOWS | 250W | 180-260Vac | 12V | 21A | >89% | >0.6 | 305*50*35mm | 800g | 2 years |
| NC-24250-TOWS | 24V | 10A | |||||||
| NC-12300-TOWS | 300W | 180-260Vac | 12V | 25A | >90% | >0.6 | 305*50*35mm | 850g | 2 years |
| NC-24300-TOWS | 24V | 12A | |||||||
| NC-12360-TOWS | 360W | 180-260Vac | 12V | 30A | >90% | >0.6 | 305*50*35mm | 880g | 2 years |
| NC-24360-TOWS | 24V | 15A |
| Characteristics | Frequency | 50/60Hz | ||||||||
| Voltage tolerance | ±5% | |||||||||
| Max Load | 80% | |||||||||
| Inrush Current((A ) | <50A | |||||||||
| Ripple&noise | <200mVP-P | |||||||||
| hold-up/start-up time time | 100ms, 30ms,20ms/ 230VAC | |||||||||
| Leakage current((mA ) | <0.5mA / 230VAC | |||||||||
| Protection | Over current | above 108%-116%,power limiting, recovers automatically after fault removed | ||||||||
| Over voltage | switch off, recovers automatically after fault removed | |||||||||
| Short circuit | hiccup mode,recovers automatically after fault removed | |||||||||
| Environment | Operating Temperature | ‘-25℃~~+50℃ | ||||||||
| Storage Temperature | ‘-30℃~~+80℃ | |||||||||
| Humidity | 20~~95% | |||||||||
| Security | LVD | 2014/35/EU | ||||||||
| EMC | 2014/30/EU | |||||||||
| Voltage Insulation/Isolation Resistance | I/P-O/P:3.75KVAC,I/P-O/P:>100M Ohms/500VDC/28℃/68% RH | |||||||||
| Classification of Installation and Use | Class I | |||||||||
| Note | ◊ All parameters NOT specially mentioned are measured at 240VAC input, max rated load and 25℃ of ambient temperature | |||||||||
| ◊ Ripple & Noise are measured at 20MHz of bandwidth by using a 300mm twisted pair-wire terminated with a 0.1uF & 47 uF parallel capacitor. | ||||||||||
| ◊ The driver is considered as a component to be operated in combination with equipment,since performance will be affected by the complete installation. | ||||||||||
| ◊ Good heat dissipation will prolong the working life of the driver.Please ensure good ventilation. | ||||||||||
| ◊ Please check if the output voltage/current of any LED lights used comply with the working voltage/current of the product. | ||||||||||
| ◊ Be ware of high power pressure may caused by short circut when installing metal casing products. | ||||||||||
| ◊ Please ensure all wires connections and polarities are correct before appling power to avoid any damages to LED Lights. | ||||||||||
| ◊ The product shall be installed and serviced by a qualified person. | ||||||||||
| ◊ Please contact supplier if a fault occurs. | ||||||||||
(Unit:cm)



